I have made progress on the project as a whole. I took down the wall on our side yard in anticpation of a driveway access to the future boat shop location. I've acquired tools and am more familiar with using them. I have also continued planning the project out and researching information about my Dad's band and reason the F/V Escape Hatch is named that way. So while I may not have done as much as I would have liked. Or worked on what I would have liked. Progress is being made. However, this project is about actually BUILDING a boat and I have yet to start. I'm very close, especially now that I have a bandsaw, but I do have a few things to do and get before I'm ready to begin construction.
My next step is getting my space setup with an assembly/layout table. I'm planning on building a torsion box assembly table out of MDF that will work with my table saw and band saw as outfeed tables as well. It will be roughly 7' X 10' with plenty of storage for tools and eventually will have an integrated dust collection system that will run off my shop vac and Dust Deputy Cyclone system I already have. I'm still in the design stage of this but estimate it will cost less than $250 when all said and done. However, I can get it up and going for around $100.
After the table is setup I can finally begin building the boat. I will first start with frames 1-4, as they seem to be the most straight-forward and don't require a 10" wide board to cut from. There are a number of items I will need to purchase in order to complete them.
I will need some of the 1-1/4" #8 bronze screws that are called for in fastening the frames together with the gussets and floor timbers. I think since I'm so close to Glen-L it will be fine to order the screws from them and have them shipped. I can get 100 for around $25, which is good enough to begin.
I will also need to purchase some epoxy, epoxy supplies, and a respirator. I'm planning on using Poxy-Shield for gluing up and encapsulating the wood. I can get a 1.2gal supply from Glen-L for $125. I should probably get a little bit of the Silica Filler as well, and I can get a pound for less than $20. The respirator will set me back about $40. Initial total for epoxy and supplies are almost $200
The final step is purchasing some lumber and a sheet or two of 1/2" Marine Plywood. I can get enough to start for less than $200. Then it's time to begin making sawdust and playing with epoxy!
All in all, I will need about $500 to really get this build started. If I were able to get 50 people to each donate $10 I would be able to start. In fact, I already have $50 from my GoFundMe campaign already set aside! That means I only need 45 more people. Even $5 will help. Skip you're extra coffee for the day (I could never ask you to go without, that would be cruel!) and help a disabled veteran pursue his dream!
So please share my FV-Escape-Hatch GoFundMe Campaign site with everyone you can think of and if you can please visit it yourself and donate today!
Thank you so much for your support!